Good gear: Moonlite rail cleats & V-Lock mount system

Ben Ellison

Ben Ellison

Panbo editor, publisher & chief bottlewasher from 4/2005 until 8/2018, and now excited to have Ben Stein as very able publisher, webmaster, and editing colleague. Panbo is going to the next level in 2019 and beyond.

8 Responses

  1. Patrick - sv Deep Playa says:

    What is the proper use of the eye on those style cleats. It’s never been clear to me.

  2. Ben Ellison Ben Ellison says:

    Good question, Patrick. I favor “what works” over “proper” and there seem to be several possibilities here. You can ignore the eye altogether, which is quicker, but your line will partially bear on the ss strap, which could cause premature wear. (Fender lines, like many others, can wear shockingly fast in rough conditions.)
    First running the working part of the line through the eye gives the most stressed part a nice bearing but means you’ll then find yourself taking it in odd directions to lock it down. You can also use the eye with a stopper knot — or bowline in lighter line — so the bitter end is captured and can’t go aloft or over board. I’m still in learning mode, but I think I like the eye.

  3. ArnieH says:

    The “eye” is for a flag halyard. You run the looped line through the eye and then you never lose the end and the flag can be raised or lowered with the line passing through the eye. I have used these little cleats before and they work pretty well. Just be aware that they can slip over time and you should check there tightness occasionally. I used a small piece of bicycle inner tube to line the railing and this helped prevent spinning and other slippage.

  4. Reinier Zwolsman says:

    Dear Ben, there is a railing cleat of Barton for many years on the market. Barton also has a stay cleat with the V shape. Much cheaper as the one you have mentioned. Best regards, Reinier

  5. Ben Ellison Ben Ellison says:

    Thanks, Reinier. The Barton looks interesting, but a less elegant design, I think. Also, I’m not sure it would cheaper here in the U.S. as it may have to be imported:
    http://www.bartonmarine.com/html/special_cleats.htm

  6. Colin says:

    Those V-Link brackets look great but how big are they and how strong would they be? Why did you remove the SS Lock Pin included with the V-Link, was it too hard to operate?

  7. Ben Ellison Ben Ellison says:

    Colin, from the V-Lock FAQ:
    “The V-Lock base is 4″ across at that top, 3 1/2″ height and 3/4″ thick. The surface of the insert to which you attach your application is 4″ square.”
    I don’t see any estimate of breaking strength but I’d guess the weakest factor in most installations will be the backing plate or washer area for the four fasteners.
    The lock pin works just fine, but it was awkward for me to release it and pull the grill up at the same time. I couldn’t imagine any scenario where the grill would pop out by itself, so I removed the pin assembly, which just unscrews.

  8. Ben Ellison Ben Ellison says:

    A Camden friend just showed some V-Lock love by submitting a photo showing how a couple of sets are used on his trimaran.

Join the conversation

Your email address will not be published.