PYI Seaview Cable Glands, even a Retrofit model

Ben Ellison

Ben Ellison

Panbo editor, publisher & chief bottlewasher from 4/2005 until 8/2018, and now excited to have Ben Stein as very able publisher, webmaster, and editing colleague. Panbo is going to the next level in 2019 and beyond.

9 Responses

  1. Those Retrofit cable glands are awesome! I can’t believe no one has come up with that before now. I can’t think of the amount of times I have had to pull something completely out just to get it through a gland!

  2. Antti N says:

    How would you get the rubber seal in place without removing the cable, or is it also split?

  3. Dan Corcoran Dan Corcoran says:

    Retrofit, great idea. PYI Seaview is on a roll, many good new products last year.

    What is the best way to put holes in those rubber things?

    • Harold Beer says:

      Scan strut suggests placing the rubber part in the freezer overnight. The hole I drilled at low speed was ragged. At high speed, the swarf was tiny chips and the hole was clean.

  4. +100 on the retrofit fitting – I have a couple of antique pass-thru fittings where I KNOW the rubber is going to just crumble when I take ’em apart – and I really don’t want to have to put on a new connector.

    • I have the same question as Antti N – is the rubber already split? I can then see freezing it, drilling the hole(s) quickly, then separating the two halves, inserting the halves around the cable(s) and finally installing the whole assembly into the plastic/SS/chromed fixtures for a leak-proof system.

      • Ben Ellison Ben Ellison says:

        Hi James, Splitting the rubber would make the drilling harder, and also you only need a cut on one side. The rubber is usually flexible enough to open around the cable. Finally, making the one cut after drilling the hole is very easy.

  5. Russell Bailey says:

    Really like the DS-Multi model – just used 2 on my center console boat with an electronics re-installation – one for 5 cables on the back of an HDS12 and the other for 3 cables on the back of an NSS12. You might be able to fit 6 cables in it but 5 was getting pretty full.

    I did not find freezing to help drilling the holes. High speed definitely helped, as did screwing the top metal piece down over the rubber block and drilling all holes while clamped.

  6. Craig Holberger says:

    Generally a great item, I’ve used them installed whole but the retrofit kit should work. My gripe is the black stain on the surrounding deck that comes from the rubber after a year or two ( and keeps bleeding out), A rubber without the “carbon-black” that is white, or a silicone or urethane grommet that doesn’t bleed onto the deck with age would be better. Advantage of the retrofit, is that the seal can be replaced after several years if needed.

Join the conversation

Your email address will not be published.